Ham Radio Antenna

SARK100 ANT SWR Antenna Analyzer Meter Tester For Ham Radio

SARK100 ANT SWR Antenna Analyzer Meter Tester For Ham Radio
SARK100 ANT SWR Antenna Analyzer Meter Tester For Ham Radio
SARK100 ANT SWR Antenna Analyzer Meter Tester For Ham Radio
SARK100 ANT SWR Antenna Analyzer Meter Tester For Ham Radio

SARK100 ANT SWR Antenna Analyzer Meter Tester For Ham Radio
SARK100 ANT SWR Antenna Analyzer Meter Tester For Ham Radio. This is a SWR Analyzer for ham hobbists. Frequency Generation & Control: 1 - 60 Mhz Source impedance: 50 Ohms Stability: +/- 100 ppm Spectral Purity: Harmonics down >- TBD dB beyond 60 MHz Step Size: User configurable increments of 100 Hz, 1 kHz, 10 kHz, and 100 kHz Usable Measurement Range:SWR: 1.0 to 9.99 Impedance: approx. 5 to 2000 ohms RF Output: Adjustable: 2.0 Volts pp (typ) Power supply: Powerd by External: 12 to 15 Volts DC, 500mA Controls: Pushbuttons (5): "Mode", "Band", "Config", "Scan", "Up", "Down" Switch: "Power On" Connectors: RF USB: Mini-B receptacle External power: 2.1mm Power Jack (center pin positive) Applications: Measure antenna electrical parameters: SWR, impedance (resistance + reactance), capacitance, inductance Measure feedpoint impedance Measure ground loss Adjust antenna tuners and determine loss Measure inductors and capacitors Measure coax transmission line (SWR, length, velocity factor, approximate Q and loss, resonant frequency, and impedance) Measure and determine optimum settings for tuning stubs: SWR, approximate Q, resonant frequency, bandwidth, impedance Determine characteristic impedance of transmission line Determine length of? Wave phasing lines Coaxial Cable Loss Determine antenna tuner loss Measure balun loss Measure inductor Q Estimate quartz crystal parameters Measure magnetic loop resonance and SWR Operation button definitions: Mode: selects operation mode: impedance(default), complex impedance, capacitance, and inducatance BAND: select band from any of the available bands: 160M to 6M CONFIG: Provides menu for configurations and extended functions: PC Link, step size setting, suspend timeout setting, calibration, and software upgrade SCAN: pressing this control initiates a scan of frequencies of the selected BAND. Scan exits to impedance mode showing the 2:1 bandwidth and the resonant point o the antenna CAN(up): increase frequency and used to cancel operation for CONFIG menu VAL(down): decrease frequency and used to validate operation for CONFIG menu. 100% Brand New :NOTE: THE BATTERY IS NOT INCLUED 1 x ANT SWR Antenna Analyzer Meter For SARK100 Ham Radio.

We maintain high standards of excellence. Feedback is very important to us. Feedback, so that we can satisfactorily address your concerns. We will try our best to solve any problem. We will reply you within 48 Hours.

We are committed to resolve all issues in a friendly and satisfactory manner. We care about our valued buyers, if you have any questions, our Customer Service staffs will be very glad to help you. We try our best to reply to your emails as soon as possible, however, due to high volume of daily incoming emails and time zone difference, we may not be able to reply your emails immediately.

The item "SARK100 ANT SWR Antenna Analyzer Meter Tester For Ham Radio" is in sale since Thursday, November 10, 2016. This item is in the category "Handys & Kommunikation\Funktechnik\Amateurfunk\Amateurfunk-Verstärker".

The seller is "kiss_buy" and is located in . This item can be shipped worldwide.

  • Herstellernummer: Nicht zutreffend
  • Marke: Herstellernummer


SARK100 ANT SWR Antenna Analyzer Meter Tester For Ham Radio