The interface cable is included. The operating is the same as the method of the Yeasu tuner, which is simple and convenient. The mAT-30 can work within the range of 3MHz to 54MHz.
The mAT-30 connects to the radio via its CAT/LINEAR jack to control the tuning cycle;the transceivers Tune button controls the tuner. The CAT/LINEAR jack also powers the tuner, so it requires no external power supply. The mAT-30 is specially engineered to integrate with your Yeasu FT-100/857/897/450D/891 HF radio. Tuning is performed when the TUNE button is pushed on the front of the transceiver and held for one second.
The mAT-30 is specially engineered to integrate with your Yeasu FT-100/857/897/450D/891 HF radio. The mAT-30 connects to the CAT (Computer Automated Transceiver) port on the back of the radio. The CAT interface allows an external device such as a PC or the mAT-30 to control the FT-100/857/897/450D/891 by sending it serial commands. The mAT-30 takes advantage of this interface to simplify the tuning process --one button push is all that is needed in order to switch the radio to FM mode, reduce output power, transmit a carrier, measure the transmit frequency, and then restore the radio to its previous mode and power level! You can also start a tuning cycle manually whenever necessary.
The mAT-30 has16,000 frequency memories. When tuning on or near a previously tuned frequency, the mAT-30 uses "Memory Tune" to recall the previous tuning parameters in a fraction of a second. If no memorized settings are available, the tuner runs a full tuning cycle, storing the parameters for memory recall on subsequent tuning cycles on that frequency. In this manner, the mAT-30 "learns" as it is to the bands and frequencies as it goes. Specification: - 0.1 to 120watts SSB and CW peak power, 30 watts on PSK and digital modes, and 100 watts on 6 meters. Latching relays for ultra - Low power operation. 16,000 memories for instantaneous frequency and band changing.Controlled from YeasuTUNE button on radio. Works with most Yeasu radios that are FC-30, FC-40 or FC-50 compatible. Partial radio list: FT-100, FT-857, FT-897, FT-450D, FT-891. Tuning time:0.1 to 5 seconds full tune, 0.1 seconds memory tune.
1.8 to 54.0 MHz coverage. Tunes 5 to 1500 ohm loads. For dipoles, verticals, Vees, beams, long wire or any coax-fed antenna.Weight:0.8Kg Package Included: - 1 x mAT-30 HF-SSB Automatic Antenna Tuner - 1 x Connecting cable. Because transit time is highly depended and provided by Postal Service. The item "120W mAT-30 HF Auto-tuner Auto Tuner Automatic Antenna Ham Radio for Yeasu UK" is in sale since Tuesday, March 27, 2018. This item is in the category "Mobile Phones & Communication\Radio Communication Equipment\Parts & Accessories\Tuners & Matchers". The seller is "rcshop2011" and is located in Portsmouth.
This item can be shipped worldwide.