Ham Radio Antenna

Ham Radio Antenna Line LMR400 50 Ohm Coax Cable PL-259 CB UHF VHF PL259 110 feet

Ham Radio Antenna Line LMR400 50 Ohm Coax Cable PL-259 CB UHF VHF PL259 110 feet
Ham Radio Antenna Line LMR400 50 Ohm Coax Cable PL-259 CB UHF VHF PL259 110 feet
Ham Radio Antenna Line LMR400 50 Ohm Coax Cable PL-259 CB UHF VHF PL259 110 feet
Ham Radio Antenna Line LMR400 50 Ohm Coax Cable PL-259 CB UHF VHF PL259 110 feet
Ham Radio Antenna Line LMR400 50 Ohm Coax Cable PL-259 CB UHF VHF PL259 110 feet

Ham Radio Antenna Line LMR400 50 Ohm Coax Cable PL-259 CB UHF VHF PL259 110 feet

Ham Radio Antenna Line LMR400 50 Ohm Coax Cable PL-259 CB UHF VHF PL259 110 feet. Shireen, Jeffa, Sheren, Cellphone Mate. Do you need your signal to reach farther across both upper and lower frequency bands?

Frustrated by signals dropping or not reaching the spot you need to complete that last contact during a contest? Bought an expensive antenna and it doesn't seem to make your signal any stronger? Antennas and cables are a system. Good antenna and a cheap cable. Will make getting the signal strength you need impossible. Not being able to get solid UHF/VHF or Microwave coverage for Ham or CB where you need it is aggravating. Home and Commercial users as well as the Military have used our cables for years to provide connectivity to critical areas where the signal has to get through. These are the guiding principles behind 50 ohm Times Microwave LMR-400 Transmission line Coax Antenna cable. Made with pride in the USA, this cable is made from quality components to ensure the optimal signal extension for your contacts. If signal strength and consistency are your concerns, this coax cable meets all your needs. It is made to exacting Times Microwave LMR specifications download the spec sheet below. And is designed to carry the strongest possible signal to your antenna. When it comes to transmission quality and peace of mind, nothing beats our coax. Our US-made products use high-precision quality control and mission critical attention to detail. Cables Produced, Assembled, and Fabricated In The USA with US Made Coax.

HAM UHF CB LMR-400 Coax Cables. PL-259 to N MALE UHF CB LMR-400 Coax Cables. Ultra Low Loss LMR-400 N male to N male Cables. Linksys, CISCO, others N male to RP-TNC Male Antenna Cables for WiFi. New RP-TNC Male to Female Cables to Extend Wireless Internet Antennas.

N Male to RP-SMA Coaxial Antenna Cables at the store page here. New RP-SMA Male to Female Cables to Extend Wireless Internet Antennas.

Need another type of cable? Specs for N Male to PL-259 UHF Male Coaxial Cables. LMR400 Ultra Low Loss - connection cable. Per Title and Headline listing ANY Length Available up to 500 Feet.

Shielded Cable - Connects Ham & CB equipment, Commercial and Radio transmitters to Antennas and equipment. Antenna & Equipment Connection cable.

We have 200 listings for Genuine LMR cable sets with different connector configurations. Whats the big deal about.

Your antenna and cable is a system. Paring your antenna with wimpy RG-58 or Cheap Commie Cable can result in more transmission loss than your antenna gains. This is especially important when you are working with Low Power or in areas of. With the wrong cable you will loose more than your antenna gains and go nowhere.

Your cable directly affects signal strength! What his cable specs are. For Contests, Pulling in that weak signal at a critical time, Reaching out in Emergencies or just talking to friends, the quality of your cable and its transmission loss is critical. Check out our quality LMR-240 and LMR-400 cables and how much signal they save you on the table to the right.

For LMR coax shown Loss is measured only on Genuine Times Microwave or Andrew / Commscope coaxial cable. Attenuation / Loss Coaxial Cable Specification. Loss shown is for 2.4GHz and 5 GHz microwave use at. Note: DB is a Logarithmic scale - 3 DB is. More loss than 1 DB. DB LOSS for 2.4GHz.

If you cut it up you keep it. Cable should be in "like new" condition, teeth marks/burns/slices etc. Please don't run it up a tower and scrape/fray it then change your mind.

Run all tests while still coiled. Coax Connector types and gender are Extremely Confusing! Please take a minute to look at the pictures to make sure you order the right ones. The ability of your antenna system to pull in the contacts you want to reach is what we provide thru high quality cables.

If you need to connect to systems in hard to reach areas or pull in the strongest possible signal to get the highest quality connections try our cables! N Connectors or Good Old PL-259.

At one time all connectors were Un-Matched. On top of that, they leaked! Then along came the N Type Connector... In order to meet the needs of increased power and reliability standards required by the Military in WWII The N connector was born.

The old PL-259 was Non Matched (Impedance that is) which is Not a Good Thing increasing loss significantly at higher frequencies. In addition, since it was never designed to be watertight it required additional maintenance and waterproofing to provide acceptable service.

N connectors were the first to be impedance matched to the equipment and cable resulting in lower insertion and transmission losses. With high quality N connectors having watertight silicone gaskets and tight tolerances waterproofing transmission line connections is much simpler. Most of the world has moved to higher standard connectors than the PL-259. If your equipment allows we recommend transitioning.

If you don't know which connector you need. Is a UV Resistant Polyethylene jacketed cable designed for. Are hallmarks of the LMR-400 cable design.

The flexible outer conductor enables. The tightest bend radius available for any cable of similar size and performance. Is another hallmark feature of LMR-400. Size for size LMR has the lowest loss of any flexible cable.

And comparable loss to semirigid hard-line cables. Is 50 dB greater than typical single shielded coax (40 dB).

The multi-ply bonded foil outer. Conductor is rated conservatively at > 90 dB i. >180 dB between two adjacent cables.

LMR-400 cables designed for outdoor exposure incorporate the best materials for UV. Resistance and have life expectancy in excess of 20 years. A wide variety of connectors are available for LMR-400 cable, including all common interface types. Reverse polarity, and a choice of solder or non-solder center pins.

Most LMR connectors employ crimp outer. Attachment using standard hex crimp sizes. Is the cable you are looking at Described as. "Compare to" "Replacement for" or "Same as" or even "Like".

This is common with poor quality cable made in Mainland China or some other lesser known locations. Our Times Microwave LMR-400 cable is US Made, tested and certified to ensure you will maintain the boost in signal from your quality antennas. 405 inch Cable is perfect for runs when you don't want to loose signal strength but it isn't cheap, so please choose a product that will last for 20+ years and give you the service you require.

What many folks fail to realize is that poor quality antenna cable will cost you all the gain you obtain from installing an external antenna or relocating your antenna to a better location. Badly made or wimpy 1/8 or 1/4 inch cable can cost you up to a Db a foot at microwave freqs! US Made Coaxial Cable Types we offer. Times Microwave LMR-400 Ultra Flex. Times Microwave LMR-400-75 (75 ohm).

Testing Results for US Made LMR Coaxial Cable. Attenuation (Signal Loss) per 100/ft - (lower numbers are better).

There are many Chinese companies quoting the same specs as Times Microwave and Andrew / Commscope Coaxial cable. There are some issues with this. Cheaper grades of cable may. With the same loss but quickly degrade over time with significant signal loss.

The Inner foil layer below the braided shield is bonded to the foam dielectric in a patented process that prevents signal leakage and moisture infiltration. On US Made Times Microwave Coaxial Cable. Mil Spec testing criteria is not followed by many Chinese offshore producers and when retested by UL cable has repeatedly failed to pass muster. Quality testing - Jacket materials, Copper alloys, and Dielectric Foam have been found to be adulterated and containing contaminants. Quality Coaxial Cable producers in China and other offshore locations they mainly produce cable for major brand name retailers who provide their own quality control, and do not sell off cable under "generic" or offbrand names.

Coax Cable Loss is Frequency Dependant - The Higher your Frequency the More Important your Coax. Loss Is Measured in DB per 100 feet. 28 Mhz (10 meters & CB).

2.5 Ghz (MW, WiFi). 5.8 Ghz (MW, WiFi). Power Capacity In Watts By MHz. Managed and operated by Kim Nelson, MPD Digital is a DBA of Kimberly Distribution LLC. We are a Small, Veteran Owned, Woman Owned, HubZone certified business. The Post Office makes this up, not us! 25 feet weighs 2.5 pounds within a few cents of the Flat Rate cost for most locales.

We do not mark merchandise values below value or mark items as "gifts" - US and International government regulations prohibit such behavior. Top same external size as RG-213/ 8u. Middle same external size as RG-8x.

Bottom same external size as RG-58. The item "Ham Radio Antenna Line LMR400 50 Ohm Coax Cable PL-259 CB UHF VHF PL259 110 feet" is in sale since Saturday, November 12, 2011. This item is in the category "Consumer Electronics\Radio Communication\Parts & Accessories\Coax. The seller is "sagemaiden" and is located in Leesburg, Georgia. This item can be shipped to United States, Canada.

  • Brand: Times Microwave Systems
  • MPN: LMR-400
  • Model: LMR-400
  • Connector: PL-259 Soldered UHF Male connectors
  • Cable: Ultra Low Loss double shielded foam dielectric
  • Country/Region of Manufacture: United States


Ham Radio Antenna Line LMR400 50 Ohm Coax Cable PL-259 CB UHF VHF PL259 110 feet