Ham Radio Antenna

EZ-TUNE ET80M HF Dipole Antenna

EZ-TUNE ET80M HF Dipole Antenna

EZ-TUNE ET80M HF Dipole Antenna

EZ-TUNE 80 Meter HF Windom Antenna. The Windom is ideal for those who want a high performance antenna with world class DX coverage. A feed line is attached to an optimum point along the dipole by a 4:1 BALUN.

Taking one vertical angle and frequency with another. If you dont have room for an 80-meter dipole or long wire or you have to restrict the length this wired antenna is for you. Outstanding performance with a tuner. Made to handle the elements.

Used by DX contesters all over the world. Overall Lenght is 133 Feet.

Made with Stranded 14awg UV insulated wire. Power 200w Key down 1500w SSB/PEP.

The antenna can be installed in three basic ways. Requires two tall supports separated by more than length of the antenna.

Suspend the antenna with at least a 50 pound working load nylon rope or another equivalent strength weather resistant non-metallic rope. Never use wire or wire core rope to support the ends of any antenna. Attach the rope to the end insulators through the empty holes. Try to keep the antenna as horizontal (level) as possible. The antenna should be at least 35 feet above ground to give acceptable performance on 40 Meters, and as high as possible for the best overall performance.

The coaxial cable should drop vertically from the horizontal section of the antenna as far as is practical. If you are using trees for end supports, be sure to allow enough slack or some type of pulley and counterweight system to prevent the antenna rope from breaking when the trees sway in the wind. Try to keep the ends of the antenna at least five feet from metallic supports.

This method requires only one tall support and also places the least mechanical strain on the antenna. Hang the center insulator of the antenna from the support using nylon or other nonconductive rope tied to the center hole of the center insulator. The center insulator will be the highest point of the antenna. If possible, position the two ends of the antenna so the inside angle they form is at least 120 degrees. Secure the antenna ends with nylon or weather resistant non-metallic rope to suitable supports.

This antenna also can be suspended as a sloping dipole. This requires one tall support and one short support.

The center (feed point) of the antenna should be at least 30 feet above the ground in this configuration. A sloping dipole radiates mainly in the direction of the downward slope. The optimum angle of "slope" will vary with the desired coverage and the frequency of operation, but will almost always be somewhere between 45 degrees and almost vertical. DON'T WAIT GET YOURS TODAY & START TALKING TOMORROW. Here is what buyers are saying about my HF line of products.

Fast shipper, exactly as described, thanks. Well made unit at a good price!

Hope you do the same upon receipt of item. Descriptions are stated to the best of my knowledge. The item "EZ-TUNE ET80M HF Dipole Antenna" is in sale since Friday, November 06, 2015.

This item is in the category "Consumer Electronics\Radio Communication\Antennas\Ham, Amateur Radio Antennas". The seller is "ham-radio-connection" and is located in Ontario.

This item can be shipped to Canada, to United States.

  • To Fit: Base Station Radio
  • Compatible Brand: Universal
  • Brand: EZ-TUNE
  • Frequency Band(s): HF
  • Country of Manufacture: Canada


EZ-TUNE ET80M HF Dipole Antenna