LDG Electronics AT-7000 Ham Radio Automatic Antenna Tuner With IC-100 Cable

LDG Electronics AT-7000 Ham Radio Automatic Antenna Tuner W/. In great shape and was used very little and it comes with IC0199 cable! The LDG AT-7000 is is the ideal tuner for your IC-7000. First, it matches up to 10:1 SWR (3:1 on 6 meters), so just about anything you can feed with coax is good to go.

And, it has 2,000 not a typo; that's 2,000! Memories, enough for every Dxpedition, RTTY spot and radio buddy you've got, and then some. Just hit the tune button on the radio, and your AT-7000 will set tuner parameters in less than a second if you've been there before.

If not, it kicks off a full tuning cycle that will be over in about 3 seconds. Don't need the tuner just now? Then just tap the Tune button briefly, and the tuner goes into bypass.

Press it again to bring the tuner back on line -- it's just that simple. The AT-7000 is just 6.5L x 6.5W x 1.25H inches 1.5 pounds, and gets its DC power directly from the radio.

No separate power supply needed. Features SO-239 input and output. The AT-7000 works with any Icom radio that supports AH-3 or AH-4 Icom antennas.

This currently includes the IC-7000. IC-706MkIIG, IC-703Plus, IC-718, IC-746 and IC-756ProIII. The AT-7000 package includes a 14 inch radio interface cable and a you're ready to operate right out of the box. IC-7000 shown above not included. Specifications: 0.1 to 125 watt power range (SSB and CW), 100W on 6M 2000 memories for instantaneous band changing.

Compatible with any Icom radio that is AH-4 or AH-3 compatible. Compatible with: 7000, 706 (all), 703, 718, 746 and 756 (all). Tuning time: 0.1 to 6 seconds full tune, 0.1 seconds memory tune.

1.8 to 54.0 MHz coverage. Tunes 4-800 ohm loads (16-150 on 6M), 4-3200 ohms with optional 4:1 Balun.

For Dipoles, Verticals, Vs, Beams or any Coax Fed Antenna. Ready to use with included Icom interface cable.

---