RRS-1903-XT Extra Tall Tilt Mount Made in USA

Extra Tall Vertical Base Tilt-Over Antenna Mount. 100 Percent Made in Evansville, Indiana USA. This is the largest tilt mount of it's kind on the market.

This is the original RRS-1903-XT! Designed and individually made by Raymond Sult N9KGC. Antenna Tilt Mount for vertical base antennas.

Measures 24 inches tall, 4.6 inches wide, X 2.6 inches. Individually made (not mass produced) from 6061 four inch aluminum channel and 3/16 steel that is used to make the outer channel. There is No Flex with this new stronger design!

Pivots / hinges on a large robust 1/2 inch pin / bolt. Is secured in place when in the "Up" position by two bolts that thread into the channel rather than using nuts and bolts as other tilt mounts. This allows for easier securing without having to reach inside the channel to hold the nuts with a wrench. This tilt mount comes with six (6) U-bolts. Two for the "Antenna" tilt-over side and two for the stationary side.

Included U-bolts work with mast or pipe up to two (2.0) inch outside diameter. If you need larger U-bolts contact me. 2.25 and 2.5 inch available. This item is fabricated after it is ordered.

If you need a custom or modified version of this item (or ANY item I make) please contact me with your request.

---