DA-1501 is a dipole wide band VHF antenna for professional radio systems. Dipole incorporates 1/4 wave coax line matching circuit optimized for wide bandwidth and accurate matching. All connections made by soldering and are the one-piece. The horizontal radiation pattern is adjusted by changing the distance between dipole elements and supporting mast. All antenna parts are made of aluminum and covered with polymer powdered coating, which is sintered at a high temperature, forming a polymer coating which resists water and ice buildup, and provides exceptional protection from corrosive gases, UV radiation, salt spray, acid rain and windblown abrasives.
All components of dipole elements are DC grounded for better lighting and anti-static protection. Frequency range 136 - 170 MHz.
Overall dimensions 90/ 110 cm. It is a serially manufactured antennas, it has high quality and reliability. Important: each antenna produced for each specific order and personal needed.Customer frequency range, so when you place the order, let me know your desired central (transmitting). Also usually we need about 15 days to produce the antenna. Due to russia's invasion of Ukraine, we are now at war and are limited in production capacity and do not powder coat the antennas yet, so they will have a natural aluminum color and will not be painted. We also produce primarily antennas for the armed forces of Ukraine. Therefore, by purchasing our products, you support the Armed Forces of Ukraine in our struggle for freedom and homeland!
Thanks for your support and understanding! Install the supplied hardware exactly as shown in the photo. Colored markers on dipole indicate upward direction. Accordingly, the drainage holes at the end of the antenna should point downward. The wavelength can be calculated by dividing 300 by the frequency in MHz.
The horizontal distance between the mast and the center of the dipole is chosen equal from 1/4 to 1/2 of the wavelength of the transmission frequency, depending on the required diagram in the horizontal plane. The mast on which the antenna is installed must be no lower than the upper edge of the dipole. The antenna mast must be grounded. If you have any questions about the assembly and installation of the antenna, please contact me.
This item is in the category "Consumer Electronics\Radio Communication\Antennas\Ham, Amateur Radio Antennas". The seller is "odessadmitry" and is located in this country: UA. This item can be shipped worldwide.