10 GHz LNB with PLL and TCXO. Simply modification of the LNB with PLL and 25 MHz X-tal. With 1 ppm TCXO there is nice 10 GHz RX for tropo and satellite. You only need some receiver - SDR or classic. 1 ppm temperature stability TCXO built in.
Voltage supply +12V for V-pol. Variable ATTENUATOR in the bias tee. High voltage / current protection. Voltage supply +12V for V-pol, +17V for H-pol.
Bias tee connectors: IN (LNB) = F, OUT = SMA and F. Option: 3D printed POTY dual band antenna adapter. 22 mm Cu tube diameter. NOTE: TCXO has got 1 ppm temperature stability and 2 ppm production frequency tolerance.It means that all pieces have got some small frequency offset. Depends on piece it is 0 to about 20 kHz. This is not a problem for SDR RX where you can set it in the software.
For LNB with 432 MHz IF you have to calculate with this offset from TX frequency. Option: RTL-SDR receiver with 1ppm TCXO. 1 ppm TCXO for better stability. SMA - SMA cable included (17 cm). 8 bit, up to 2 MHz of spectrum.
Compatible with: HDSDR, SDR console etc. Different 10 GHz and IF FQ. Tropo / EME / QO-100. The item "10 GHz LNB with TCXO for QO-100,10489 to 432 MHz with POTY adapter + bias tee" is in sale since Monday, February 17, 2020. This item is in the category "Consumer Electronics\Radio Communication\Ham, Amateur Radio\Other Ham Radio Equipment".
The seller is "jan_2zaw" and is located in Zdar nad Sazavou, default. This item can be shipped worldwide.