NEW custom built HIGH POWER 80 meter EFHW (End Fed Half Wave) multi band antenna matching transformer. Maximum Power 1500 watts I. Optimized for 80 meter half wave long wire with 49-1 Impedance match. (Primary 2 turns, Secondary 14 turns).
Constructed with THREE toroids and wound with 14 gauge Copper Magnet Wire. Case vented to remove heat and moisture (condensation).
Just add 125 ft of wire recommend 14 AWG insulated wire. Home Depot Southwire 500 ft roll 14 gauge Black Stranded CU THHN wire hung as an inverted L, inverted V, etc. And trim for minimum SWR on your desired portion of the 80 meter band and you will have a multi-band antenna that performs well on 80 meter, 40 meter, and 20 meter bands. I have the identical transformer in use with an inverted L antenna wire.
I routinely talk with stations in Europe, Ukraine, Russia, etc. DIRECTIONS FOR USE: Connect 130 feet of 14 gauge insulated wire in inverted L or inverted V configuration. Connect Ground terminal on transformer to Ground Rod ideally 8 foot ground rod below transformer with heavy duty ground wire. Connect 50 ohm coax recommend high quality low loss cable, eg. RG 213, DXE 400 max, LMR400, or equivalent to transformer and shack output ie..
Using your antenna analyzer trim far end length to achieve SWR minimum at desired frequency or 3.700 Mhz. This item is in the category "Consumer Electronics\Radio Communication\Antennas\Ham, Amateur Radio Antennas". The seller is "mooneypilot" and is located in this country: US. This item can be shipped worldwide.