GA-800 Shortwave Antenna Active Loop Antenna 10KHz-159MHz HF for Radios BNC-SMA

This antenna GA800 has built-in signal amplification circuit and noise suppression circuit, which can effectively amplify the signal and reduce the impact of noise. Under the same environmental conditions, its noise control effect is 20% higher than that of GA450.

The main body of the antenna is composed of a power control box and an outdoor antenna which can be separated by a connecting feeder or without a feeder, and the loop body and the power control box are directly connected. The specific method of use depends on your own environment.

Antenna loop size: 260mm/10.2 (inner diameter). Control box: 107 x 65 x 26mm/4.2 x 2.6 x 1.

Power supply mode: TYPE-C charging/built-in 18650/2600mAh. Charging circuit: built-in battery protection circuit to protect the battery from over-discharging and over-charging. It will automatically disconnect when the battery voltage is lower than 2.5v. 1 x Antenna with control box. 1 x BNC cable (5m/16.4ft).

1 x Power cord (Type-c). 2 x Output cables (BNC-3.51m/3.3ft; BNC-BNC1m/3.3ft). Note: - GA800 can try a variety of suspension methods according to different usage scenarios. The deal state is to raise the receiving ring through the mast, away from the building, and introduce it into the room through a feeder. Pay attention to waterproofing and lightning protection while listening. The outdoor part of this antenna is not waterproof.

If you need to place it outdoors for along time, you need to take waterproof measures by yourself.

---