The coil bobbin is made by die-cutting. The material is nylon, non-ppr pipe is made by hand. The strength is very high. The coil is now wound with 1.0mm 304 stainless steel wire, which has higher strength and overcomes the deformation of tinned copper wire. The weakness is that all the screws are made of stainless steel screws, and the vibrator aluminum tube is sandblasted and oxidized into black.
Note that it is not a simple aluminum rod and two screws. This is an aluminum tube.
Even if it is erected horizontally, the sag is very high. Small, not as drooping as an aluminum rod is very serious. The base is oxidized to black, and the custom 2.5 m stainless steel rod antenna is used for higher strength and the communication efficiency is greatly improved. Antenna Features: - Light weight, small size and easy to carry - Can work easily in multiple bands - Easy and fast to set up. It can be set up in 3 minutes by one person - Very suitable for field stand, business trip or balcony erection - The coil bobbin is made by die-cutting.
It is made of non-manual car. The coil is wound with 1.0mm stainless steel wire. All screws are made of stainless steel - Aluminum tube blasted into black, the base is oxidized to black, very beautiful and graded - Customized 2.5 m stainless steel rod antenna Antenna Performance Parameters: - Weight is about 1.4Kg - The length of the contraction is about 34.5cm, and the length of the erection is about 410cm. Frequency: can work in 8 bands of 40, 30, 20, 17, 15, 12, 10, 6 meters (7Mhz-50Mhz) - Impedance: 50O - Withstand Power: 100W - Standing Wave: 40m band SWR. Usually it cost about 35USD-50USD.
This item is in the category "Consumer Electronics\Radio Communication\Antennas\Ham, Amateur Radio Antennas". The seller is "cybereveryday" and is located in this country: CN. This item can be shipped worldwide.